I have been running BFDeco and just upgraded to BFD 2.2. One trap others might fall into is that during the BFD 2 install process, I was asked if I wanted to check for updates. Of course, it located BFD2.2 and I set about installing that - but couldn't complete that because I still had four DVDs of the original program to install. So I aborted that, finished the BFD2 installation and then ran the upgrade.
All seemed to go okay, but now, when I try to open a preset kit, it opens with blank kit pieces and I have to manually load each piece. Is there a way of fixing this or will have to uninstall and reinstall?